What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 22.06.2025 00:53

Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–16 [ OO OLAOYE OYEBODE ]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Gut Microbiota Transplants May Cause Long-Term Imbalance - Neuroscience News
What is lightning?
Upvotes:
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
One
Can the fuse protect the electronic devices from lightning instead of a surge protector.
[old diagram got deleted by accident]
We've Finally Seen The Skyscraper Tsunami That Shook Earth For 9 Days - ScienceAlert
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Because the load is inductive, the current lags the voltage.(by a bit).
Scherzer makes 1st rehab start in return from thumb issue - MLB.com
what exactly is a ‘surge’ protector?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
What are the best Jewish jokes?
but I think this circuit , shows a few more pieces.
but this device (an Inductor) … impedes the rapid changes in the current.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Having Low Levels Of This Vitamin Can Cause Dry Eyes. Are You Getting Enough? - Women's Health
What does a fuse do?
He then describes Rainy Season and Lightning.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
so, what happens?
But… the neutral is now “floating” because of the 1 ohm resistance.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
In schematic diagrams this is the symbol for a fuse:
But it can get overloaded, and no longer works.
The third is lightning and “how it gets conducted into a home.”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is where the MOV conducts again, and dissipated the energy.
Mundfish Reveals The Cube, An MMORPG Shooter Set In The Atomic Heart Universe - Game Informer
He then asserts :
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
So, the voltage could go up to 500 volts, and the fuse will not open up.
How might an Indian girl respond to someone saying "I love you"?
Edit 2024–10.
eight
The MOV will conduct when the voltage exceeds 50% of line voltage.
He then describes the function of a fuse.
At one ohm, the resistor has a maximum of 1 watt power.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
There are two important concepts here.
The bolt then partially travels down the line to your home.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
I can not sleep. what is the problem?
Here is a simplified AC power diagram.
It seems Mohan does not understand the difference between a comment and an Answer.
These are simplified answers to the original question, and does not change anything I wrote above.
Stock Market News, June 3, 2025: Nasdaq Moves Higher; OECD Cuts U.S. Growth Outlook - WSJ
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
A circuit breaker is similar, but is resettable.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
a photo is worth a thousand words.
These devices are installed between the “hot” and “neutral” and protective ground.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
A fuse is a non-resetable over current circuit protector.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This device then solves the entire problem.
This is 'the assistant's answer'
For this case there are devices called Metal oxide varistors (MOV).
There are three different concepts here that are getting confused.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
One is “what exactly is in a ‘surge protector’ ? ”
This is where this question deviates from being a 'generic' question, and becomes more specific.
2024–10–14 [Omar Gharbi Omar Gharbi ]
(Dc diagram shown, AC is similar).
I post the exact comment here.
nine
First Sentence:
An AC voltage/ current source, and an ac inductive load.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This one hit behind the barn.
At least they know the answer if they wanted it.
It also is a device that limits the change in current flow.
Barnstars:
The other is “what does a “fuse” do?”
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
[image of Common-mode choke]
2024–10–10[John johnson John Johnson ]
the problem then depends on "how fast does the fuse operate?".
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?